Articles
| Open Access |
DOI: ANGREN SECONDARY KAOLINITE CLAYS IN THE PRODUCTION OF ALUMINOSILICATE PROPPANTS
Bayraeva Nasiba Ashurbayevna , PhD student, Institute of General and Inorganic, Chemistry of Academy of Sciences of the Republic of Uzbekistan Khomidov Fakhriddin Gafurovich , PhD, Institute of General and Inorganic Chemistry of Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan Adizov Bobirjon Zamirovich , Doctor of Chemical Sciences, Prof. Institute of General and Inorganic, Chemistry of Academy of Sciences of the Republic of UzbekistanAbstract
The article presents the results of studying the chemical-mineralogical and physical-mechanical characteristics of Angren secondary kaolin and kaolinite clay and their suitability for obtaining aluminosilicate proppants. It was found that the melting point of Angren secondary kaolin is 1540 ° C and the compressive strength in the fired at a temperature of 1400 ℃ reaches up to 105 MPa, and for kaolinite clay these indicators showed 1505 ℃ and 109 MPa, respectively. The obtained indicators suggest that these clay materials can be used as the main component for obtaining aluminosilicate proppants.
Keywords
kaolin, proppant, kaolinite
References
Yatsenko E. A., Chumakov A. A., Tretyak A. A. The influence of the addition of slag waste from the Novocherkassk SDPP on the properties of aluminosilicate materials based on drill wastes from the Vostochno-Chumakovskoye oil field. Steklo i keramika. 2024. No.97(07). P.29-34.
Pauliukevich Yu. G., Laryionov P. S., Kavrus I. V. Influence of structural factors on the mechanical strength of glass-ceramic propants. Steklo i keramika. 2023. No.96(1). P.22-27.
Reshetova A.A., Alferova A.I. Use of kaolins of the Ural-Siberian region in the technology of ceramic aluminosilicate proppants. Proceedings of the XIV International scientific and practical conference of students and young scientists "Modern equipment and technologies". Tomsk - 2008. Tomsk: TPU Publishing House. 2008. P.156-157.
Vakalova T.V., Reshetova A.A., Pogrebenkov V.M., Vereshchagin V.I. Activation of the process of mullite synthesis and sintering of aluminosilicate ceramics based on refractory clay raw materials. Refractories and technical ceramics. 2009. No. 7 - 8. P. 74 - 80.
Abdrakhimova E.S., Abrakhimov A.V., Abdrakhimov V.Z. Polymorphic transformations of Si02 in clay materials of different chemical and mineralogical composition. Materials Science. 2002. No. 7. P. 35 - 41.
GOST 26423-86. Refractory materials and products. Methods for determining silicon dioxide.
Kutsevol M.L. X-ray method of diagnostics and qualitative phase analysis of minerals. Practical guide to laboratory work in the discipline “Laboratory methods for studying minerals.” Dnepropetrovsk 2012. P. 35p.
ASTM Standards Part 17. “Refractories, Glass, Ceramic Materials, Carbon and Graphite Products” ASTM. Philadelphia. 2005. P. 7-9, 51-61.
Kadirova Z.R., Eminov A.M., Hujamberdiev M.I., Boyjanov I. Prospective Kaolins in Uzbekistan. Tile & Brick International. 2003. Vol.19. No.4. P.252-257.
Eminov A.M., Sabirov B.T., Negmatov S.S., Sargsyan A.S., Kadyrova Z.R. Physicomechanical studies of new kaolins in the production of aluminosilicate composite ceramics. Composite materials. Publ. GUP "Fan va tarakkiyot", Tashkent. 2016. No. 4. P. 24-30.
Eminov A.M., Kadyrova Z.R., Sarkisyan O.S., Hujamberdiev M.I. Kaolin «Alliance»-new ceramic raw material. I Investigation of chemical-mineralo-gical composition. DVS – Verlag CmbH (Germany). 2004. No11. Р 72-75.
Article Statistics
Downloads
Copyright License
Copyright (c) 2024 Bayraeva Nasiba Ashurbayevna, Khomidov Fakhriddin Gafurovich , Adizov Bobirjon Zamirovich
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.