Engineering and Technology
| Open Access |
DOI: STUDY OF WATER INFLUENCE ON WATERPROOFING MATERIAL "POLYISOL-M"
Abstract
The paper presents the results of experiments to study the properties of water absorption and water resistance of the waterproofing material "Polyisol-M". As a result of experimental analysis the water absorption capacity of the waterproofing material "Polyisol-M" with thickness of 5 mm was 0,59 %, and the value of mass loss was 2,42 %, therefore it was recommended to use it in production.
Keywords
Component, mixture, oil sludge
References
Musaev M.N., Rakhmatova D.M., Rakhimov B.B. Comparative tests of pilot batches, bitumen-replacement mixtures // Universum; Technical Sciences Scientific Journal Issue:10(91) October 2021, Moscow, Part 3., - P. 80-84.
Rakhmatova D.M., Musaev M.N., Rakhimov B.B., Khamidov B.N. International journal of advanced research in science, engineering and technology // ISSN: 2350-0328 Obtaining bitumen-substitute mixture from local waste oil and oil-fat production Vol. 8, Issue 10, October 2021. Р 18386-18389.
Khamidov B.N., Urinov A.A. Physical and mechanical parameters of bitumen composition obtained from the residues of oil and oil-fat industry // Universum; Technical Sciences, Scientific Journal, Issue: 5 (98) May 2022, Moscow, Part 8. -С. 65-67.
Khamidov B.N., Urinov A.A. Water absorption and water resistance of the waterproofing material "Polyisol - M" // UNIVERSUM; TECHNICAL SCIENCES, Scientific Journal, Issue: 5 (98) May, 2022, Moscow, Part 8., - P.. 68-70.
Umarov S.S. Physico-chemical aspects of the influence of complex additive on bitumen aging in the conditions of the Republic of Tajikistan: Dissertation of candidate of technical sciences: 05.23.05. - Dushanbe, 2018. -149 с.
Negmatov J.N. Development of compositions and technology for obtaining modified water-soluble powdered gossypol resins for the production of composite polymer drilling reagents: Graduate qualification work - Tashkent, 2018, -89 p.
Download and View Statistics
Copyright License
Copyright (c) 2023 The American Journal of Engineering and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.