Articles
| Open Access |
DOI: Study Of The Influence Of The Parameters Of The Sampling Zone On The Condition Of The Capture Of Fibers By The Drum Teeth
Jamshid Qambaralievich Yuldashev , Candidate Of Technical Sciences, Associate Professor, Head Of The Department Of “Metrology, Standardization And Quality Management”, Namangan Institute Of Engineering Technology, Uzbekistan Husankhon Tokhirovich Bobojanov , Doctor Of Technical Sciences, Associate Professor, Head Of The Department Of “Technology Of Textile Products”, Namangan Institute Of Engineering Technology, UzbekistanAbstract
The article presents and discusses the results of determining the diameter of the sampling drum on
the basis of theoretical research and substantiating the rational parameters of the system for hanging
the fibers of the discrete drum headset in the sampling zone of the pneumatic mechanical spinning
machine. The forces of interaction between the garniture teeth and the fibers were studied, and the
effect of the sampling process on the productivity and quality parameters of the fibers was analyzed.
Based on the research, graphical connections were obtained, these graphs were analyzed, and optimal
parameters were determined. The results of theoretical studies on the determination of the diameter
of sampled drum and justify the rational parameters of the system.
Keywords
Fiber,, , sampling,
References
Bat M.I. and others. Theoretical
Mechanics. Moscow: Nauka, 1968. – p.
Yuldashev J.Q., Umarov A., Sarimsakov
O. Dynamics of Interaction of a Single
Fiber with a Headset of a Sampling
Drum Engineering, 2020. 12, 347-355
https://www.scirp.org/journal/eng
Bobajonov H., Yuldashev J., Gafurov J.
The arrangement of the fibers in the
yarn and effect on its strength. IOP
Conference Series: Materials Science
and Engineering (2017)
Yuldashev J.K., Jumaniyazov K.J.,
Dzhuraev A.D., Matismailov S.L.
“Calculation of the friction force of the
fibers on the front face of the tooth of
the sampling drum of the spinning
machine” Farpi Scientific-Technical
Journal 2018 Issue 2. – pp. 134-136
Yuldashev J.K. Dissertation on the
study of the degree of candidate of
technical sciences. “Increasing the
quality of pneumatic mechanics with
the use of multifunctional navigation
headsets”, 2011
Article Statistics
Copyright License
Copyright (c) 2020 The American Journal of Engineering and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.