Articles
| Open Access |
DOI: Impact Of Reinforcing The Infill Dividers With Punctured Steel Plates On The Conduct Of RC Casings
Aysun Celik , Associate Professor, Kirikkale University, TurkeyAbstract
The Reinforcing of the non-bearing components of a design not just builds the general horizontal strength and firmness of the construction, yet in addition purposes a significant measure of the seismic tremor energy to be consumed by the nonbearing individuals and in this manner decreases the danger of harm in the primary parts. The current paper centers around various trials did inside a broad exploration program, examining the impact of fortifying the block infill dividers of a RC outline with punctured steel plates on the seismic conduct of the edge. Punctured steel plates are embraced in fortifying because of their few benefits including the extraordinary ductilities and twisting limits of these plates, the heat proof, recyclable and non-cancerogenic nature of steel and the simplicity of utilization of this procedure.
Keywords
Block facade, Tremor Conduct, Steel Plate, Primary Reinforcing
References
Pietikainen, M., Hadid, A., Zhao, G. and Ahonen T. (2011): Computer Vision Using Local Binary Patterns. Series Computational Imaging and Vision, Vol. 40, 212p, Springer.
El-Dakhakhni, WW, Hamid, AA, Hakam, ZHR & Elgaaly, M 2006, ‘Hazard mitigation and strengthening of unreinforced masonry walls using composites’ Composite Structures, vol. 73, no. 4, pp. 458-477.
Rodrigues, M., Kormann, M., and Tomek, P. (2014b): A comparative analysis of binary patterns with discrete cosine transform for gender classification. In: Mastorakis, N, et al. (eds.) Advances in information sciences and applications: Proceedings of 18th International Conference on Computers (part of CSCC'14). Recent advances in computer engineering series, 1 (22), 3337.
Domanski, P. A. (1989) EVSIM An Evaporator Simulation Model Accounting for Refrigerant and One Dimensional Air Distribution. National Institute of Standards and Technology (NIST), Gaithersburg, USA.
Hassan, J. M., Tarrad A. H. and Abdullah, M. N. (2009) A dynamic modeling capability for subcritical vapor compression refrigeration system. Engineering and Technology Journal, 27 (13), p.2319-2338.
Sadler, E. M. (2000) Design Analysis of a Finned-Tube Condenser for a Residential Air Conditioner using R22. MSc thesis, The Academic Faculty, Georgia Institute of Technology.
Ozbek, E, Kalkan, I, Akbas, SO & Aykac, S 2014, ‘Influence of strengthening with perforated steel plates on the behavior of infill walls and RC frame’ International Journal of Civil, Structure, Construction and Architectural Engineering, vol. 8, no. 5, pp. 494-499.
Article Statistics
Copyright License
Copyright (c) 2021 The American Journal of Engineering and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.