Articles
| Open Access |
DOI: Increase The Wear Resistance And Service Life Of Dyes Based On Modern Technologies
Nomanjonov S.N. , Ferghana Polytechnic Institute, UzbekistanAbstract
The main ways to increase the durability of the working parts of the stamping tool are considered, including the processes of cold plastic deformation during the application of wear-resistant coatings by ion-plasma spraying. A physical model of the process of cold plastic deformation of samples from heat-resistant steel X12M is presented.
Keywords
Stamp, mold, mechanical activation
References
Increasing the durability of working surfaces of parts of dies and molds made of heat-resistant steels. Morozov O.I., Tabakov V.P., Kokorin V.N., Titov Yu.A. Bulletin of the Tula State University. Technical science. Issue 11: at 3 pm Ch1. Tula: Publishing house of Tula State University, 2017.64-68 p.
Odintsov L.G. Strengthening and finishing of parts by surface plastic deformation: a reference book. M .: Mashinostroenie, 1987.S. 70-116. 324
Chernyavsky A.O. Finite element method. Basics of practical application. FSBEI HPE "SUSU" (NRU). [Electronic resource]. URL: http://pent.sopro.susu.ac.ru/LRN/0711/smm/files/ fea_4c.pdf
Wang H. et al. Direct and continuous strain control of catalysts with tunable battery electrode materials, 2016. Science 354. P. 1031-1036.
Article Statistics
Copyright License
Copyright (c) 2020 The American Journal of Engineering and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.