Development Of A Principal Diagram Of A High-Efficiency Coefficient Of A Frequency Inverter
Tursunov Azizbek Shokirjon O'g'li , Lecturer In The Department Of Electric Engineering, Electric Mechanics And Electric Technologies, Fergana Polytechnic Institute, Uzbekistan Abduraximov Dostonbek Raximjon O’g’li , Lecturer In The Department Of Electric Engineering, Electric Mechanics And Electric Technologies, Fergana Polytechnic Institute, UzbekistanAbstract
The article developed frequency converters with increased efficiency for industrial enterprises. The principle of operation of existing methods and circuits of frequency converters has been studied and a schematic diagram of a highly efficient coefficient of a frequency converter has been developed.
Analyzes switching currents in power switches of frequency converters, energy losses associated with switching, losses associated with output rectifiers, improves analysis of the main power consumption in a switching power supply, high-frequency variable frequency control system efficiency, high power dissipation and high timing diagram for automated systems explaining the principle of operation of frequency variables with a useful operating coefficient, a new block diagram of improved frequency variables were developed, the circuit was changed, and an increase in efficiency was achieved.
Keywords
Frequency converters
References
Pike, A.A. (2005). Electronics. Tutorial. Ed. prof. AS Sigova. SPb .: BHV-Petersburg.
A. I. Karmanyuk (2006). Electronics and circuitry: a textbook. - Tyumen: TyumGnSU. p. 96.
Zeldin, E.A. (1991). Pulse devices on microcircuits. Radio and communication. p. 160.
Chizhenko, I.M., Andrienko, P.D., Baran, A.A., & Vydolop, Yu. F. (1978). Handbook of converting technology Ed. IM Chizhenko. p.447.
Abramovich, M.I., Babailov, V.M., & Lieber, V.E. (1992). Diodes and thyristors in converter installations. - 432p.
Hoshimov O.O., Imomnazarov A.T. (2015). Energy saving in electromechanical systems. 2nd edition. Textbook for higher education institutions.-Tashkent: Science and technology, .155 p.
Rekus, G.G. (2005). Electrical equipment of production: Textbook. allowance. M .: Higher. shk. p.342.
Imomnazarov A.T. (2010). Electrical equipment I and power supply of mining enterprises. Tashkent: Finance. p.165.
Imomnazarov AT, A'zamova G.A. (2014). Energy saving modes of asynchronous motors. Monograph.-Tashkent: TDTU, p.140.
Найманбаев, Р., & Камбарали, К. Ҳ. (2019). Faraday effect afn-planks. Scientific Bulletin of Namangan State University, 1(10), 8-11.
Mukhammadjonov, M. S., Tursunov, A. S., & Abduraximov, D. R. (2020). Automation of reactive power compensation in electrical networks. ISJ Theoretical & Applied Science, 05 (85), 615-618.
O’G’Li, A. D. R., & O’G’Li, R. I. N. (2019). Problems of using alternative energy sources. Проблемы современной науки и образования, (12-1 (145)).
Article Statistics
Copyright License
Copyright (c) 2020 The American Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.