Articles
| Open Access |
DOI: Analysis Of Methods For Increasing The Efficiency Of The Use Of Crushing Working Bodies Of Crushers
Batırbay Kosımbetov , Sr. Assistant Karakalpak State University, Karakalpakstan, UzbekistanAbstract
The article examines the principles of operation and distribution of cone crushers when crushing nonmetallic materials. Significant results have been achieved in improving the efficiency of work at the Karatau open pit. Practical work on equipment deformation was carried out. When crushing rocks, individual rock fragments were obtained in a standard manner.
Keywords
Ore and nonmetallic materials, Cone crushers, wear, career Karatau, power, Crushing efficiency, deformations, pieces of mountain breeds
References
GOST 6937-91. Cone crushers. General technical requirements. "Mechanical equipment of enterprises of building materials", Moscow: publishing house of standards, 2008.
Lagunova Yu. A. Reserves for increasing the efficiency of equipment for ore preparation // Mining machines and automation. 2004. №. 3. S. 49-53.
Sapozhnikov M.Ya. Mechanical equipment of enterprises of building materials and structures / M.Ya. Sapozhnikov - M .: Higher school, 1971, -382s.
Gerasimenko VB, Fadin YM . Technical foundations for creating machines, Belgorod, BSTU publishing house. 2014.119 p.
Krivov D.A. Problems of using roller crushers for grinding grain crops // Materials of the XIV International Scientific and Practical Conference "Science and Education: Experience, Problems, Development Prospects", Krasnoyarsk, 2016, p. 55-56.
Article Statistics
Copyright License
Copyright (c) 2021 The American Journal of Engineering and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.